B1859005S INDUCER BLOWER ASSEMBLY - GMP
Click To Enlarge

B1859005S INDUCER BLOWER ASSEMBLY - GMP

= Packard/Fasco 66005

FOR GOODMAN MODELS:

  • GMP050-3
  • GMP075-3
  • GMP075-4
  • GMP100-3
  • GMP100-4
  • GMP100-5
  • GMP125-4
  • GMP125-5
  • GMP150-5
  • GMPE075-3
  • GMPE075-3A
  • GMPE100-4
  • GMPE100-4A
  • GMPE125-5
  • GMPE125-5A
  • GMPH050-3
  • GMPH075-4
  • GMPH080-5
  • GMPH120-5
  • GMPV075-1.5
  • GMPV075-3
  • GMPV100-3
  • GMPV100-5
  • GMPV125-3
  • GMPV125-5
  • GPD050-3
  • GPD075-3
  • GPD100-4
  • GPD125-4

This Item Replaces

Amana B4059001
Emerson F33JCS-3655
Emerson 2569
Emerson 3106
Fasco 7002-2307
Fasco 7002-2771
Fasco 7002-3219
Fasco 7058-0229
Goodman 7058-0229
Goodman B1859005
Goodman B1859005S
Goodman B40590-35
Goodman 7002-3219
Goodman 7002-2771
Goodman 7002-2307
Goodman 4MH09
Goodman J238-11128
Goodman J238-112-11128
Goodman R7-RFB185
Jakel J238-112-11128
Jakel J238-11128
Mars 10703
Rotom RFB185
Rotom RFB595
Rotom FB-RFB185
Rotom FB-RFB595

Inducer Fan Assembly 
The inducer fan motor is a small motor usually in the gas burner compartment and this small fan or blower is required to pull the hot gasses through the heat exchanger so that those gasses are blown into the flue vent.

The inducer fan motor must be run properly with a safety pressure switch connected to the inducer fan blower housing with a small rubber tube. If the inducer fan motor is not proven on then the gas furnace heating unit should stop. It and may try the same sequence a couple more times after a time delay but if it continues to fail to run the heating unit will usually shut off and lock out. 

This can be caused by a faulty pressure switch, a bad rubber tube or in some cases the inducer fan or blower itself is not working correctly. An alternative cause for failure could be a blockage in the gas vent flue.   

Older gas furnace heating units (generally all pre-2000) do not have an inducer fan and are natural draft units, most of these heating units have been replaced by the new fan inducer technology. 

These heating units usually do not have a control board or have a much simpler version of a control board which is usually just an ignition control unit. 

Not all Draft Inducer Fan Assemblies look alike and they are not interchangeable.

  • Item #: B1859005S

B1859005S INDUCER BLOWER ASSEMBLY - GMP

Price: $143.98
* Marked fields are required.
Qty: *
Reviews (0) Write a Review
No Reviews. Write a Review